System Information" Tab; Data Maintenance" Tab; Fabrication" Tab; Comments" Tab - Siemens COMOS Operating Manual

Preparing for creation and maintenance of pipe specs
3.5 Administering pipe part catalogs
3.5.12

"System information" tab

The tab is used in the Isometrics module.
3.5.13

"Data maintenance" tab

The tab is used for data management.
3.5.14

"Fabrication" tab

The tab is used in the Isometrics module.
You can find more information on this topic in the "Isometrics" manual, keyword "Adapting
dimensions".
3.5.15

"Comments" tab

You can enter remarks about the pipe part here.
3.5.16

"3D geometry" tab

The attributes of the tab are of importance for pipe spec administration and for the generation
of 3D objects.
Setting for all 3D attributes
3D mode must be activated for all 3D attributes:
Properties of the attribute, "Link" tab, "Mode": "On"
3.5.16.1

"General" control group

The "3D geometry" tab has the following general geometry attributes:
Control element
"Standard"
"In the report, only use
the symbol for the re‐
quirement"
50
Description
● Displays the selected system of standards.
● Linked to "Y00T00060.Y00A00038 NSys"
Option which is relevant for P&IDs if the P&ID catalog is linked to the pipe
part catalog. See also chapter Retaining the request as the report object
(Page 130).
PipeSpec Designer
Operating Manual, 09/2014, A5E32076948-AA