Clean Or Replace Wetted Parts - Teledyne Platinum Pocket Manual

5.5 Clean or Replace WettedParts
For general cleaning, you can wash the strainer
and sample bottles with a brush and warm
soapy water and then rinse with clean water.
You can clean the liquid path through the
wetted parts by placing the strainer in a
cleaning solution and pumping it through the
delivery system. Next, place the strainer in
clean water and pump it through the delivery
system to rinse it. If these items are severely
contaminated, replace them.
5.5.1 Sampler Cleaning Guidelines
Keeping the sampler clean and protected from
harsh elements may extend the usable life of
the sampler. When necessary, clean the exterior
and interior of the sampler and sample
chamber with warm soapy water and brush,
then rinse with water. Be sure to use a
detergent that is compatible with low-density
polyethylene, polystyrene, PVC, ABS,
polycarbonate and NORYL™
strong solvents and acids.
1. NORYL is a registered trademark of SABIC
Innovative Plastics IP B.V.
Section 5 Maintenance
1
. Avoid using
5-11