Table of Contents
Advertisement
2.4.1 24-1 Liter
The 24 bottle configurations use a rack to hold
and align the containers. To install the bottles
in the refrigerator using the rack:
1. Place the uncapped bottles into the rack.
Install bottle retaining ring and fasten with
the 3 bungee cords.
2. Pull the sequential table forward. (Platinum
only).
3. Locate the arrow in center of the rack and
align it with the center block located on the
turn table.
4. Roll the sequential table back into the
sampler. (Platinum only).
5. Activate the program to R
will turn to locate #Bottle 1. After the table
has stopped make sure the discharge tube is
centered on the bottle. If the discharge tube
is not centered, rotate/adjust the discharge
tube to the center of the bottle.
Note
Bottle caps can be stored in the center of the bottle
rack.
Figure 2-1 Bottle rack with 24-1 liter bottles
Section 2 Installation
and the table
UN
2-9
Advertisement
Table of Contents
