Setup & Operation 2. Specifications
2.3 Part Names and Outer Dimensions
2.3.1 LS3
Standard-Model LS3-401S
Brake release switch
Arm #2
MT label
(only for custom
specification)
Signature label
(Serial No.
of Manipulator)
CE label
NOTE
- The brake release switch affects only Joint #3. When the brake release switch is
- While the LED lamp is on, the current is being applied to the manipulator.
18
LED lamp
Joint #3
Shaft
pressed in emergency mode, the brake for Joint #3 is released.
Performing any work with the power ON is extremely hazardous and it may result in
electric shock and/or improper function of the robot system. Make sure to turn OFF
the controller power before the maintenance work.
Arm #1
Fittings (black or blue)
for ø6 mm
pneumatic tube
i
F
ttings (white)
for ø6 mm
pneumatic tube
Base
Fittings (black or blue)
for ø4 mm pneumatic tube
User connector
(15-pin
D-sub connector)
Power cable
Signal cable
LS Rev.10