Ricoh SP 330SN User Manual page 262

7. Configuring the Machine Using the Control Panel
Printer Registration
Adjust the registration of each tray if necessary. You can adjust the registration value between -15
and +15 (that is, -1.5 and +1.5 mm, in 0.1 mm increments).
Default: 0 for all parameters
Item
Horiz.: Tray 1
Horiz.: Tray 2
Vert.: Tray 1
Vert.: Tray 2
Horiz.: Bypass
Tray
Vert.: Bypass
Tray
Horiz.: Duplex
Unit
Vert.: Duplex
Unit
Low Humidity Mode
Item
Low Humidity
Mode
260
Select this to adjust the tray 1 registration horizontally.
Select this to adjust the tray 2 registration horizontally.
Select this to adjust the tray 1 registration vertically.
Select this to adjust the tray 2 registration vertically.
Select this to adjust the bypass tray registration horizontally.
Select this to adjust the bypass tray registration vertically.
Select this to adjust the registration of the back of duplex printing horizontally.
Select this to adjust the registration of the back of duplex printing vertically.
Description
If the machine is used in a room where
humidity level is low, black lines of a
few millimeters thick may appear on
printouts with 75-millimeter spaces in
between. Selecting [On] for this setting
may prevent these lines from
appearing (wait for about one day
until this setting becomes effective).
Note that when this setting is enabled,
the machine automatically performs
self-maintenance in every 10 minutes.
Description
Value
• Off
• On
Default: [Off]