Ricoh SP 330SN User Manual page 207

1. Press the [Home] key.
2. Press the [Fax] icon on the [Home] screen.
3. Place the original on the exposure glass or in the ADF.
To place the originals, see page 89 "Placing Originals".
4. Select [Address Book], [Manual Entry], or [Redial].
If you select [Redial], confirm the destination, and then proceed to Step 7.
5. Enter the fax number (up to 40 characters), or specify a destination.
• For details about entering characters, see page 46 "Entering Characters (When Using the
Touch Panel Model)".
• For details about specifying destinations, see page 209 "Specifying the Fax Destination".
• If the machine is connected to the telephone network through a PBX, make sure to enter the
outside line access number specified in [PBX Access Number] before the fax number. For [PBX
Access Number], see page 271 "Administrator Tools Settings (When Using the Touch Panel
Model)".
6. Press [OK].
7. Press the [Start] key.
• Depending on the machine's settings, you may be prompted to enter the fax number again if
you manually entered the destination fax number. In this case, re-enter the number within 60
seconds, and then press the [Start] key. If the fax numbers do not match, go back to Step 5.
DYG322
DYG336
Sending a Fax
205