Table of Contents
Advertisement
Display Status Indicators
The following table describes the status information provided by the UPS If another indicator not shown
appears, see
Indicator
Standby Mode
Online mode
Battery mode
1 beep every 10 seconds
End of backup time
1 beep every 3 seconds
High Efficiency mode
Bypass mode
Status Indicators
Figure 46.
Changing Parameter Settings
The LCD display menus can be selected to show measurements, change control settings and show UPS and
event logs. Use the two middle buttons (
(
) button to select an option (see Figure 48 to Figure 62).
Chapter 11, "Troubleshooting"
Status
The UPS is Off, waiting for startup
command from user. The
indicator flashes continually.
The UPS is operating normally. The
indicator is on steady
A utility failure has occurred and the
UPS is on Battery mode.
The UPS is on Battery mode and the
battery is running low.
The UPS is operating on High
Efficiency mode.
An overload or a fault has occurred,
or a command has been received,
and the UPS is in Bypass mode.
for additional information.
Equipment is not powered until
Green LED blinking when UPS is in Standby mode.
The UPS is powering and protecting the equipment.
.
The UPS is powering the equipment with the battery
power.
Prepare your equipment for shutdown.
Low Battery Warning settings: [Capacity] [0%]...[100%]
[Runtime] [0mn]...[60mn]
The alarm triggers when the set percentage of battery
capacity or remaining back-up time is reached.
The UPS is powering and protecting the equipment
Equipment is powered but not protected by the UPS.
and
) to scroll through the menu screens then press the Enter
Eaton 9PXM UPS (4-20 kVA) User's Guide
Description
button is pressed.
P-164000669—Rev 05
Operation
57
Advertisement
Table of Contents
