Table of Contents
Advertisement
Installation Setup
To set up 8- or 12-slot cabinets:
1.
Move the UPS shipping pallet close to the desired location.
2.
If installed, remove the straps and bracket bolts that attach the UPS to the pallet (see Figure 7).
3.
If you are rack-mounting the UPS, proceed to "Rack-Mount Installation" on page 12.
Bracket Bolts
Figure 7. UPS on Shipping Pallet
4.
Attach the supplied ramp to the pallet with the two brackets and four wood screws provided (see
Figure 8).
5.
Retract the leveling feet by turning them clockwise then carefully roll the cabinet down the ramp to its
intended operating location (see Figure 8).
Pallet Front
Figure 8. Moving the UPS from the Pallet
NOTE
10
Eaton 9PXM UPS (4-20 kVA) User's Guide P-164000669—Rev 05
(8)
Pallet
Bracket
Pallet Rear
For ease of installation, determine if you have sufficient clearance at the rear of the
UPS to complete the electrical connections before securing the UPS in its final
position (see Chapter 4, "UPS Electrical Installation")
Caster Cart
Leveling Feet
(4)
Screws
Ramp
Ramp
Advertisement
Table of Contents
