Table of Contents
Advertisement
Installation Setup
Figure 12. Remove Cabinet from Caster Tray
4.
Carefully slide the UPS from the caster tray onto the rail tray in the equipment rack until the rack-mount
ears of the cabinet are almost flush with the front vertical rails of the rack. Install metal clip nuts in the rack
in line with the upper mounting brackets. Install the provided screws (see Figure 13).
5.
Install the provided screws into the lower rack mount ears to the threaded holes in the rail tray (see
Figure 13).
Screws
Figure 13. Securing the UPS in the Rack
6.
If you are installing an optional EBM cabinet P-103002494, refer to Chapter 5, "Battery Cabinet
Installation" on page 39.
14
Eaton 9PXM UPS (4-20 kVA) User's Guide P-164000669—Rev 05
Rear Bracket
Screws
Rack Mount
Ears
UPS Cabinet
Note: Attach appropriate
lifting device and use at
least two people to lift the
UPS cabinet
Slot Tabs
Caster Tray
Equipment Rack
Rails
Rail Tray
Advertisement
Table of Contents
