Change The Rear Bulbs - Seat Ateca 2018 Owner's Manual

Note
Due to the difficulty of accessing fog light
bulbs, have them replaced at a Technical
Service or specialised workshop.

Change the rear bulbs

Overview of tail lights
Tail lights on side panel
Turn signal
Side light and brake light
Tail lights on the rear lid
Left side
Side lights
Fog light/side light
Reverse light
Right side
Side lights
Reverse light
The table corresponds to a right-hand traffic
vehicle. The position of lights may vary ac-
cording to the country.
100
Rear bulbs (in the side panel)
Fig. 114
PY21W NA LL
tail light unit.
P21W LL
P21W LL
P21W LL
W16W
Retaining tabs on reverse side of tail
Fig. 115
2x P21W LL
light.
W16W
Follow the steps indicated:
1. Check which of the bulbs is defective.
2. Open the rear lid.
Emergencies
Boot: access to the bolt securing the
3. Remove the lid, levering it with the flat
side of a screwdriver into the recess
›››
Fig. 114 .
1
4. Remove the bulb connector.
5. Unscrew the light securing bolt by hand
›››
or using a screwdriver Fig. 114
6. Remove the light from the body, gently
pulling it toward you, and place on a
clean, smooth surface.
7. Disassemble the bulb holder unlocking
›››
the securing tabs Fig. 115
8. Change the damaged bulb.
9. To refit follow the steps in reverse order,
taking special care when fitting the bulb
holder. The securing tabs must click into
place.
CAUTION
Take care when removing the rear light unit
to make sure there is no damage to the
paintwork or any of its components.
Note
Make sure you have a soft cloth ready to
●
place under the glass on the rear light unit,
to avoid any scratches.
In the case of LED lights, change only the
●
turn signal bulb.
.
2
.
1