Seat Ateca 2018 Owner's Manual page 296

Indications on the instrument panel
display
On the instrument panel display: Indi-
Fig. 267
cation on the Lane Assist system display (ex-
ample 1).
294
Driving
On the instrument panel display: In-
Fig. 268
dication on the Lane Assist system display (ex-
ample 2).
Status display
– The system is active, but not available,
either because the minimum speed has
not been reached or because the lane
›››
lines are not recognised
– The system is active and available, both
lane lines are recognised. The steering
angle is not being corrected at this mo-
›››
ment Fig. 267 B.
– The system is operational, the highligh-
ted line
A
of involuntarily crossing the lane line and
that the steering is being adjusted to
correct the angle
– The two highlighted lines
multaneously when both lane lines are
recognised and the Lane Assist function
›››
is active
Operating mode
Steering wheel vibration
The following situations can cause vibration
in the steering wheel and require the driver to
take active control of driving:
When the steering angle assist value re-
●
quired to keep the vehicle in the lane is higher
than the system's maximum operating value.
If the system ceases to display the lane
●
lines while assisting with steering.
Switching the Lane Assist system on or off
Through the Easy Connect system
Press the Easy Connect button
●
Fig. 267 A.
Press the function button SETTINGS >
●
Driver assistance
Or: Using the Driving Assist button on the
turn signal lever*
indicates that there was a risk
›››
Fig. 268 C.
light up si-
A
Fig. 268 D.

to open the menu.
›››
page 124.