Creating an Offroad tour
Offroad route guidance mode
Fig. 231
Start route guidance
Loads the stored Offroad tour.
●
Starting off in a stored route is not detected
●
by the system automatically.
Setup
Function button: function
: Reverses the direction of the stored Offroad
Invert
tour.
: Starts the Offroad tour from the nearest
Next point
point.
: Starts the complete Offroad tour.
Start
When route guidance starts, the system
switches to the map view.
Operating modes
Stopping route guidance
Press the
button on the screen and
●
Options
then press
.
Stop
End waypoint navigation
Press the
function button in the Off-
●
EXIT
road Navigation menu.
WARNING
Terrain features are disregarded during
route guidance Drive slowly and following
the instructions in order to perform the ma-
noeuvre as far as possible!
The general direction of travel is indica-
●
ted straight ahead by direction arrows in
the Infotainment System pop-up window
›››
Fig. 231
.
A
Note
If an Offroad tour is being recorded, this is
automatically stored if Offroad navigation
is discontinued.
Vehicle Menu
Introduction to using the Vehicle
menu
By pressing button
of the infotainment
system you will access its main menu with the
following options:
VIEW
●
MINIPLAYER, in the top right corner (Radio
●
or Media function if the HDC descent con-
trol* is not active).
PREVIOUS-NEXT (to change screen)
●
›››
SETTINGS
page 36
●
With the function button
you can ac-
VIEW
cess the following information:
Sport*
If the corresponding equipment is available,
the information that appears in the Sport op-
tion is the following:
1.
Instantaneous power expressed in kW
2.
G forces
3.
Turbo pressure, expressed in bar ("bar"),
kilopascals ("kPa") or in pounds per
square inch ("psi"). Press the Setup but-
ton to change the units of pressure.
4.
Coolant temperature
5.
Oil temperature
»
231