Seat Ateca 2018 Owner's Manual page 58

Central wheel trim*
Correct positioning of the central
Fig. 74
wheel trim for steel rims.
The central trims must be removed for access
to the wheel bolts.
Removing
Attach the wire hook (vehicle tools) to one
●
of the chambers of the central wheel trim.
Insert the box spanner through the hook,
●
supporting it on the tyre and remove the
wheel trim.
Fitting
Fit the central wheel trim onto the rim. The
●
bottom of the "S" of the SEAT badge should
align with the inflation valve
Press the central trim firmly until it locks in
●
with an audible click.
56
Note
There is also a valve mark on the back of
the central wheel trim that indicates the
correct alignment.
Wheel bolt caps*
Wheel: wheel bolts with caps.
Fig. 75
Removal
Fit the plastic clip (vehicle tools
●
›››
Fig. 73
›››
place Fig.
Remove the cap with the plastic clip.
●
›››
Fig. 74 .
1
The essentials
) over the cap until it clicks into
7
75.
Anti-theft wheel bolts
Anti-theft wheel bolt with cap and
Fig. 76
adapter.
Remove the wheel cover* or the cap*.
●
Insert the special adapter (vehicle tools)
●
onto the anti-theft wheel bolt and push it on
as far as it will go.
Insert the wheel brace (vehicle tools) onto
●
the adapter as far as it will go.
›››
Remove the wheel bolt page
●
Note
Make a note of the code number of the an-
ti-theft wheel bolt and keep it in a safe
place, but not in your vehicle. If you need a
new adapter, you can obtain it from the
SEAT Official Service, indicating the code
number.
57.