Seat Ateca 2018 Owner's Manual page 152

Audible warnings to advise the driver that
the lights have not been switched off
If the key is not in the ignition and the driver
door is open, an audible warning signal is
heard in the following cases: this will remind
you to turn the light off.
When the parking light is on
●
When the light switch is in position
●
WARNING
The side lights or daytime running lights
are not bright enough to illuminate the road
ahead and to ensure that other road users
are able to see you.
Always use your dipped beam head
●
lights if it is raining or if visibility is poor.
WARNING
If the headlights are set too high and not
used correctly, there is a risk of dazzling or
distracting other road users. This could re-
sult in a serious accident.
Always make sure that the headlights are
●
correctly adjusted.
1)
On vehicles equipped with rear LED lights, the
rear side light is switched on as well.
150
Note
The legal requirements regarding the use
of vehicle lights in each country must be
observed.
Daytime running lights
›››
page 150.
or .
 
The daytime running lights consist of individu-
al lights, integrated in the front headlights. By
connecting the daytime running lights, these
lights are switched on
The daytime running lights switch on every
time the ignition is switched on, if the switch is
in positions
exterior lighting.
When the light switch is in position
sensor automatically switches dipped beam
on and off (including the control and instru-
ment lighting) or the daytime running lights
depending on the level of exterior lighting.
WARNING
Never drive with daytime lights if the road
●
is not well lit due to weather or lighting
conditions. Daytime lights do not provide
enough light to illuminate the road properly
or be seen by other road users.
Operation
›››
1) .
or , according to the level of
 
, a light

On vehicles with rear lights with bulbs,
●
when activating the daytime running light
the rear lights are not switched on. A vehi-
cle which does not have the rear lights on
may not be visible to other drivers in the
darkness, in the case of heavy rain or in
conditions of poor visibility.
Turn signal and main beam lever
Read the additional information carefully
›››
 page 34
Push the lever all the way down to turn off the
corresponding function.
Convenience turn signals
For the one-touch signalling, when the igni-
tion is switched on, move the lever as far as
possible upwards or downwards and release
the lever. The turn signal will flash three times.
One-touch signalling is activated and deacti-
vated in the Easy Connect system via the
button and the function button SETTINGS >
Lights > One-touch signalling
›››

page 36.
