Seat Ateca 2018 Owner's Manual page 153

Table of Contents

Advertisement

In vehicles that do not have the correspond-
ing menu, this function can be deactivated in
a specialised workshop.
WARNING
Improper or lack of use of the turn signals,
or forgetting to deactivate them can con-
fuse other road users. This could result in a
serious accident.
Always give warning when you are going
to change lane, overtake or when turning,
activating the turn signal in good time.
As soon as you have finished changing
lane, overtaking or turning, switch the turn
signal off.
WARNING
Incorrect use of the headlights may cause
accidents and serious injury, as the main
beam may distract or dazzle other drivers.
Note
If the convenience turn signals are oper-
ating (three flashes) and the other conven-
ience turn signals are switched on, the ac-
tive part stops flashing and only flashes
once in the new part selected.
The turn signal only works when the igni-
tion is switched on. The hazard warning
lights also work when the ignition is switch-
ed off.
Lights and visibility
If a trailer turn signal malfunctions, the
control lamp will stop flashing (trailer turn
signals) and the vehicle turn signal will
flash at double speed.
The main beam headlights can only be
switched on if the dipped beam headlights
are already on.
In cold or damp weather conditions, the
headlights, tail lights and turn signals may
mist up inside temporarily. This is normal
and in no way effects the useful life of the
vehicle lighting system.
Automatic dipped beam control
*

The automatic dipped beam control is merely
intended as an aid and is not able to recog-
nise all driving situations.
When the light switch is in position
vehicle lights and the instrument panel and
switch lighting switch on and off automatical-
›››
ly in the following situations
running lights on page
150:
Automatic switch-
Automatic switch-
ing on
ing off
The photo sensor de-
When adequate lighting
tects darkness, for exam-
is detected.
ple, when driving through
a tunnel.
Automatic switch-
ing on
The rain sensor detects
rain and activates the
windscreen wipers.
WARNING
If the road is not well lit and other road
users cannot see the vehicle well enough
or at all, accidents may occur.
The automatic dipped beam control
(
) only switches on the dipped beam

when there are no changes in brightness,
and not, for example when it is foggy.
Main beam assist (Light Assist)*
The main beam assist acts within the limits of
the system and depending on environmental
, the

and traffic conditions. Once switched on, the
system is activated as of a speed of about 60
km/h (37 mph) and is deactivated below
in Daytime
about 30 km/h (18 mph)
When the system is activated and the cam-
era detects other vehicles that may be daz-
zled, the main beam is automatically switch-
ed off. Otherwise, the main beam is automati-
cally switched on.
The main beam assist generally detects illu-
minated areas and deactivates the main
Automatic switch-
ing off
When the windscreen
wipers have been inac-
tive for a few minutes.
›››
.
»
151

Advertisement

Table of Contents
loading

Table of Contents