Change The Rear Bulbs - Seat Ateca 2016 Owner's Manual

Fog light: remove the bulb holder
Fig. 107
Follow the steps indicated:
›››
1. Remove the screw
the fog light grille using a screwdriver
and extract the grille.
2. Remove the screws (3x)
and extract the fog light.
3. Remove the metal clip situated on the
upper part of the fog light by pulling to-
wards the exterior of the vehicle
4. Remove connector
the bulb.
5. Turn the bulb holder
clockwise and pull.
6. Remove the bulb by pressing on the
bulb holder and turning it anticlockwise
at the same time.
7. Installation involves all of the above
steps in reverse sequence.
8. Check that the bulb works properly.
96
Note
Due to the difficulty of accessing fog light
bulbs, have them replaced at a Technical
Service or specialised workshop.

Change the rear bulbs

Overview of tail lights
Tail lights on side panel
Turn signal
Fig. 106 A from
1
Side light and brake light
Tail lights on the rear lid
›››
Fig. 106 B
2
Left side
Side lights
Fog light/side light
3
›››
Fig. 107 from
1
Reverse light
Right side
›››
Fig. 107 anti-
2
Side lights
Reverse light
The table corresponds to a right-hand traffic
vehicle. The position of lights may vary ac-
cording to the country.
Emergencies
PY21W NA LL
P21W LL
P21W LL
P21W LL
W16W
2 x P21W LL
W16W
Rear bulbs (in the side panel)
Luggage compartment: access to the
Fig. 108
bolt securing the tail light unit.
Retaining tabs on reverse side of tail
Fig. 109
light.
Follow the steps indicated:
1. Check which of the bulbs is defective.
2. Open the rear lid.