Speed Limiter - Seat Ateca 2018 Owner's Manual

Table of Contents

Advertisement

If the system detects a fault that could af-
fect the working order of the CCS.
If you press and maintain the accelerator
pedal for a certain time, driving faster than
the stored speed.
If the dynamic driving control systems inter-
vene (e.g. ASR or ESC).
If the airbag is triggered.
WARNING
Use of the cruise control could cause acci-
dents and severe injuries if it is not possible
to drive at a constant speed maintaining
the safety distance.
Do not use the cruise control in heavy
traffic, if the distance from the vehicle in
front is insufficient, on steep roads, with
several bends or in slippery circumstances
(snow, ice, rain or loose gravel), or on floo-
ded roads.
Never use the CCS when driving off-road
or on unpaved roads.
Always adapt your speed and the dis-
tance to the vehicles ahead in line with visi-
bility, weather conditions, the condition of
the road and the traffic situation.
To avoid unexpected operation of the
cruise control system, turn it off every time
you finish using it.
It is dangerous to use a set speed which is
too high for the prevailing road, traffic or
weather conditions.
276
Driving
When travelling down hills, the CCS can-
not maintain a constant speed. The vehicle
tends to accelerate under its own weight.
Select a lower gear or use the foot brake to
slow the vehicle.
WARNING
›››
Observe the safety warnings
trol and warning lamps on page

Speed limiter

Control lamp
It lights up green
The speed limiter is switched on and active.
Flashes green
The speed set by the speed limiter has been excee-
ded.
It lights up
The adaptive cruise control (ACC) and the speed
limiter are active.
Some warning and control lamps will light up
briefly when the ignition is switched on to
check certain functions. They will switch off
after a few seconds.
WARNING
Observe the safety warnings
trol and warning lamps on page
Display indications
in Con-
124.
On the instrument panel display: indi-
Fig. 251
cations of the speed limiter status.
The speed limiter helps avoid exceeding a
speed individually programmed upwards of
approximately 30 km/h (19 mph) driving in
forwards gears
Display messages on the speed limiter
›››
Status
Fig.
251:
The speed limiter is active. The last speed
A
set is displayed in large figures.
The speed limiter is not active. The last
B
speed set is displayed in small or dark-
ened figures.
›››
in Con-
124.
›››

Advertisement

Table of Contents
loading

Table of Contents