Using The Instrument Panel - Seat Ateca 2018 Owner's Manual

Vehicles with analogue instrument panel
Press and hold the button
●
›››
Fig. 123 for more than 5 seconds to
4
consult the service message
Vehicles with digital instrument panel
The date of the service can only be read
●
through the Service menu
Resetting service interval display
If the service was not carried out by a SEAT
dealership, the display can be reset as fol-
lows:
Vehicles with analogue instrument panel
Switch off the ignition, press and hold but-
●
›››
ton Fig. 123
4

Switch ignition back on.
●
Release the button and press it
●

again for the next 20 seconds.
Vehicles with digital instrument panel
The service interval display can only be re-
●
set through the Service menu
Do not restart the indicator between the
service intervals, otherwise the information
displayed will be incorrect.
If the oil change service is reset manually, the
service interval display changes to a fixed
service interval, also in vehicles with Flexible
oil change service.
122
Note

The service message disappears after a
●
few seconds, when the engine is started or
when
screen wiper lever, or
tion steering wheel.
In vehicles with the LongLife system in
●
›››
page 112.
which the battery has been disconnected
for a long period of time, it is not possible to
calculate the date of the next service.
Therefore the service interval display may
not be correct. In this case, bear in mind the
maximum service intervals permitted
›››
page
If you reset the display manually, the next
●
service interval will be indicated as in vehi-
cles with fixed service intervals. For this
.
reason we recommend that the service in-
terval display be reset by a SEAT author-
ised Dealer.

Using the instrument panel

›››
page 112.
Introduction
With the ignition switched on, it is possible to
read the different functions of the display by
scrolling through the menus.
In vehicles with multifunction steering wheel,
the multifunction display can only be operat-
ed with the steering wheel buttons.
Operation
is pressed on the wind-
OK/RESET
on the multifunc-
OK
368.
Some menu options can only be read when
the vehicle is at a standstill.
WARNING
Distracting the driver in any way can lead
to an accident and cause injuries.
Never use the menus on the instrument
●
panel display while the vehicle is in motion.
Note
After loading or changing the 12-volt bat-
tery, check the system settings. If the pow-
er supply is interrupted, the system settings
might be incorrect or deleted.
Operation with the windscreen wip-
er lever
Windscreen wipers lever: control but-
Fig. 132
tons.