Seat Ateca 2018 Owner's Manual page 89

Replace the repaired tyre with the tyre
●
mobility set as soon as possible.
The sealant is a health hazard and must
●
be cleaned immediately if it comes into
contact with the skin.
Always keep the tyre mobility set out of
●
the reach of small children.
Always stop the engine, apply the hand-
●
brake lever firmly and engage gear if using
a manual gearbox, in order to reduce the
risk of vehicle involuntary movement.
WARNING
A tyre filled with sealant does not have the
same performance properties as a conven-
tional tyre.
Never drive faster than 80 km/h
●
(50 mph).
Avoid heavy acceleration, hard braking
●
and fast cornering.
Drive for only 10 minutes at a maximum
●
speed of 80 km/h (50 mph) and then check
the tyre.
For the sake of the environment
Dispose of used or expired sealant observ-
ing any legal requirements.
Note
A new bottle of sealant can be purchased
at SEAT dealerships.
Self-help
Note
Take into account the separate instruction
manual of the tyre mobility set* manufac-
turer.
Contents of the tyre mobility sys-
tem*
Standard display: contents of the an-
Fig. 100
ti-puncture kit.
The anti-puncture kit is located underneath
the floor covering in the luggage compart-
ment. It includes the following components
›››
Fig. 100:
Tyre valve remover
1
Sticker indicating maximum speed "max.
2
80 km/h" or "max. 50 mph"
Filler tube with cap
3
Air compressor
4
Tube for inflating tyres
5
Warning provided by tyre pressure moni-
6
toring system (it can also be integrated in
the compressor).
Air bleed screw (in its place, the compres-
7
sor may have a button).
ON/OFF switch
8
12 volt connector
9
Bottle of sealant
10
Spare tyre valve
11
The valve insert remover has a gap at
1
the lower end for a valve insert. The valve in-
sert can only be screwed or unscrewed in this
way. This also applies to its replacement part
.
11
WARNING
When inflating the wheel, the air compres-
sor and the inflator tube may become hot.
Protect hands and skin from hot parts.
●
Do not place the hot flexible inflator tube
●
or hot air compressor on flammable mate-
rial.
Allow them to cool before storing the de-
●
vice.
If it is not possible to inflate the tyre to at
●
least 2.0 bars (29 psi / 200 kPa), the tyre is
too badly damaged. The sealant is not in a
»
87