Table of Contents
Advertisement
Key to the
Fig.
293:
Symbol
Meaning
Front camera area
A
Right camera area
B
Rear camera area
C
Left camera area
D
Exit the current display.
Three-dimensional views
Depending on the equipment: con-
necting and disconnecting the Park-
Pilot sound.
Adjust the display: bright, contrast
and colour.
The aerial view is generated by combining
the images from all the cameras
›››
Fig.
293. The aerial view can be selected
by pressing the vehicle in the area.
Select the corresponding view by pressing
›››
the different areas
Fig. 293
aerial view or the reduced aerial view.
Conditions necessary for the use of the
Area View system
The doors and the rear lid must be closed.
●
324
The image must be reliable and clear. For
●
this reason, for example, the camera lens
must be clean.
The area around the vehicle must be clear-
●
ly and totally visible.
The area for parking or manoeuvring
●
should be a flat surface.
The vehicle should not be loaded very
●
heavily at the rear.
The driver must be used to the system.
●
There should be no damage to the vehicle
●
in the camera area. If the position or installa-
tion angle of the cameras have been
changed, e.g. after a rear-end collision, the
system should be checked by a specialised
workshop.
Camera image view
Aerial view (bird's eye view): to obtain a
●
panoramic view of the vehicle
mensional views, from different camera posi-
tions.
Front camera (front view): to observe traf-
●
fic ahead of the vehicle (vehicles crossing)
to
of the
A
D
, for front parallel parking
proaching an obstacle and in off-road driving
.
Side cameras (side view): to view the area
●
close to the sides of the vehicle, both on the
left
and on the right
both sides
Driving
, three-di-
, when ap-
, or a combination of
.
Rear camera (rear view): To observe traf-
●
fic behind the vehicle (vehicles crossing)
for reverse perpendicular parking
verse parallel parking
and for hitching a
trailer to the vehicle
.
The selected view is displayed on the right
side of the screen. The reduced aerial view
shown on the right side displays the view
framed in yellow. In addition, the right margin
of the screen displays the menu options pos-
sible and the views (the so-called "modes")
of the camera in question. The active view
(mode) at the time is highlighted.
The reduced aerial view can be hidden by
pressing the
symbol to thus display the se-
lected view full-screen.
Instructions for use
Centre console: button for activat-
Fig. 294
ing/deactivating the Area View system manual-
ly in combination with the parking aid system
(
) or else with the rear ParkPilot system (
,
, for re-
).
Advertisement
Chapters
Table of Contents
