Table of Contents
Advertisement
Current fuel consumption
fuel consumption display operates
throughout the journey, in litres/100 km;
and with the engine running and the ve-
hicle stopped, in litres/hour.
Average fuel consumption
fuel consumption is displayed after driv-
ing for approximately 300 metres.
This indicates the hours
Travelling time
(h) and minutes (min) since the ignition
was switched on.
Approximate distance in
Operating range
km that can still be travelled if the same
driving style is maintained.
or Autonomy
Adblue Autonomy
mate distance in km that can still be
travelled with the current level of the
®
AdBlue
tank with the same driving style.
The indication appears from a range of
less than 2,400 km and cannot be de-
1)
activated.
Distance covered in
Distance travelled
km (m) after switching on the ignition.
The average speed will be
Average speed
shown after driving for approximately
100 metres.
Current speed displayed in
Digital speed
digital format.
1)
Not available in all countries.
Instruments and warning/control lamps
The current
Convenience consumers
the connected comfort systems that in-
crease energy consumption, e.g. air
conditioning.
Set a speed warning
The average
Select the display Speed warning at
●
or Speed warning at --- mph .
--- km/h
Press the button
●
wiper lever or the button
tion steering wheel to store the current speed
and activate the warning.
Activate: adjust to the desired speed within
●
5 seconds using the rocker switch
windscreen wiper lever or by turning the
Approxi-
thumbwheel on the multifunction steering
wheel. Next, press the button
again or wait several seconds. The speed is
stored and the warning activated.
Deactivate: press button
●
. The stored speed is deleted.
The warning can be adjusted for speeds be-
tween 30 km/h (18 mph) and 250 km/h
(155 mph).
Display Oil temperature
The engine reaches its operating tempera-
ture when, under normal driving conditions,
the oil temperature is between 80°C and
Displays a list of
120ºC
and the outside temperature is high, the en-
gine oil temperature can increase. This does
not present any problem as long as the warn-
ing lamps
pear on the display.
on the windscreen
on the multifunc-
The system runs a check on certain compo-
nents and functions when the ignition is
switched on and while the vehicle is moving.
on the
Faults displayed on the instrument panel as
red and yellow warning symbols accompa-
nied with messages and
or
pending on the case, even an audible warn-
ing. The representation of the messages and
symbols may vary depending on the version
or button
of the instrument panel.
Existing faults can also be checked manually.
To do so, open the menu Vehicle status or
Vehicle
Priority 1 warning (red).
. If the engine is under a lot of stress
›››
or
page 351
Warning and information messages
(Vehicle status)
›››
page
›››
page
111.
The symbol lights
up or flashes (in part accompanied by
audible warnings).
Stop driving! Dan-
ger! Check the fault and eliminate the
cause. If necessary, seek professional
assistance.
do not ap-
40, de-
»
113
Advertisement
Chapters
Table of Contents
