Analyzer Remote Control; Remote Desktop - Planar IT-100 Operating Manual

Multisystem tv analyzer

Table of Contents

3) Copy the bs2 firmware updating file to the IT-100 disk root partition;

4) Disconnect the Analyzer from the PC;

5) Wait until the firmware updating process is completed.

To update firmware using the file stored at the USB flash drive:

1) Copy the bs2 firmware updating file to the flash drive root partition;

2) Connect the USB flash drive to the Analyzer;

3) Wait until the firmware updating process is completed.

The firmware updating process is indicated at the progress bar. If the firmware

updating is completed successfully, the Analyzer will start with the new program.

4.13. Analyzer Remote Control

Remote control of the device allows to send commands to the Analyzer from the

distant PC, get access to the Analyzer's desktop, and also work with the files of the

internal drive of the Analyzer.

Remote control is provided through ETHERNET interface. Before starting please

make sure, the Analyzer network interface is set up (section 4.10.5). Antivirus software

and firewall on the distant PC should not block applications for remote control.

Access to the Analyzer remote desktop is performed via VNC protocol. To control the

Analyzer on the distant PC, you need to install any of the available VNC clients (for

example, UltraVNC, TightVNC or RealVNC). Testing was executed by using the VNC

client UltraVNC Viewer version 1.2.1.7. The program settings for working with the Analyzer

(picture 4.72) is shown below:

To configure you should complete the following actions:

1) In the «VNC Server» window you should select IP address or the Analyzer's

domain name which the connection is made to;

2) Choose the «MANUAL» option in the «Quick Options» menu;

3) Set the «Save connection settings as default» mark to use the specified

settings as the default settings for subsequent program launches;

4) Press the «Options...» button to activate manual setting;

5) In the appeared window set the «Auto select best settings» mark in the

«Format and Encoding» menu;

6) Set the «Japanese keyboard» mark in «Mouse and keyboard» menu;

7) Press the «OK» button to accept modifications;

Figure 4.72

Table of Contents