Planar IT-100 Operating Manual page 13

The lower panel (figure 2.4) has a cover under which the communication ports for
connecting the Analyzer with the external devices and the external power source
connector are located. Below are air gates.
Do not close the air gates during the Analyzer operation. This may cause the
Analyzer overheating!
The upper panel (figure 2.5) includes the input RF connector and optical connector.
Figure 2.4
The right panel (figure 2.6) has the CAM module compartment cover fixed by two
captive screws.
The CAM module port and eject button are inside the compartment (figure 2.7). In
order to install or remove the CAM module, unscrew the captive screws using the
screwdriver included in the package. The right screw should be unscrewed completely to
allow the compartment cover rotate freely on the left screw, which should be unscrewed by
half the first. The CAM module should be installed face (surface A) down to the
bottom of the Analyzer.
To remove the module, press the eject button.
Figure 2.6
13
Figure 2.5