Planar IT-100 Operating Manual page 52

− «F2 / New».
− «F3 / Delete».
− «F4 / Rename». Renaming the configuration in cursor position.
− «F5 / Drive».
USB flash drive.
− «F6 / Select».
modes.
4.4.10.2. LNB Configuration common parameters handling
The LNB configuration common parameters screen view is shown in figure 4.37.
The following parameters are available for configuring:
1) Name. LNB configuration name;
2) LNB type. LNB converter type. Use the «◄» and «►» keys to select one of the
typical converter types. Press «ENTER» or «F1 / Edit» key to edit selected
converter parameters (section 4.4.10.3).
in the LNB configuration;
3) LNB satellite. Satellite, which signal is received by the converter. Use the «◄»
and «►» keys to select one of the satellites of the Analyzer (section 4.4.11). Use
alphanumeric keyboard to find a satellite with its orbital position. Press «ENTER»
or «F1 / Edit» key to edit selected satellite parameters (section 4.4.11.2).
indicates satellite that is stored in the LNB configuration;
Press «F3 / LNB+» or «F4 / LNB-» to specify converters number. To exit the mode
and save the changes, use the «F6 / Save» key. To exit the mode and discard changes,
use the «EXIT» key.
4.4.10.3. LNB Configuration converter parameters handling
The common converter parameters table view is shown in figure 4.38.
Creating a new configuration.
Deleting the configuration in cursor position.
Configurations source drive selecting: internal drive or
Selecting the configuration for operating in measurement
Figure 4.37
52
icon indicates converter that is stored
icon