Tv Video And Sound Analysis Procedure; General Information - Planar IT-100 Operating Manual

There is the name and identification information of the selected table at the top of the
window. The table of detailed information contains the following parameters:
1) Table repetition period, ms. The average repetition period of all sections of the
table in ms. If the repetition period exceeds the defined limit, the value is
displayed on the red background;
2) Table repetition period above maximal limit, counter. The number of times
repetition period of all sections of the table exceeds defined limit during the
analysis. If the value is more than 0, it is displayed on the red background;
3) Section repetition period below minimal limit, counter. The number of times
any two sections of the table arrival interval is less than the defined limit during
the analysis. If the value is more than 0, it is displayed on the red background;
4) Table version changed, counter. The number of times the table version is
changed during the analysis;
5) CRC error, counter. The number of times CRC error in the table sections occurs
during the analysis. If the value is more than 0, it is displayed on the red
background;
6) Section 0 repetition period above maximal limit, counter. The number of
times the repetition period of section 0 of the EIT table (current/following event)
exceeds defined limit during the analysis. If the value is more than 0, it is
displayed on the red background;
7) Section 1 repetition period above maximal limit, counter. The number of
times the repetition period of section 1 of the EIT table (current/following event)
exceeds defined limit during the analysis. If the value is more than 0, it is
displayed on the red background;
8) Section 0 or 1 is not present, counter. The number of times the section 0 or 1
of the EIT table (current/ following event) is missing. If the value is more than 0, it
is displayed on the red background;
9) Time left since last table arrival, min. Time in minutes passed from the last time
the RST table appeared in the transport stream.

4.7. TV Video and Sound Analysis Procedure

4.7.1. General Information

The TV video and sound analyzer is used for real-time control of TV decoded signal.
The mode allows decoding signal, displaying video at the built-in display and controlling
audio at the built-in loudspeaker.
Figure 4.61
81