Limit Plans - Planar IT-100 Operating Manual

plans table saving the new channel plan in the DL memory. You can change the channel
plan name if necessary.

4.3.13. Limit plans

4.3.13.1. Limit Plans List
Limit plans contain channel parameters check criteria and are used for
measurements in the channel data logger mode.
This mode allows performing all operations with the limit plan (LP): reading, editing,
deleting, creating a new LP, selecting an LP for checking in the measurement modes. The
screen view of the limit plan list is shown in figure 4.22.
The table indicates the limit plan name, the current limit plan, date of creating or
editing. Limit plans in the table are arranged by their names. The «Switched off» limit plan
is always located in the upper line of the table and cannot be edited.
The functional keys enable the following operations with limit plans:
− «F1 / Edit».
− «F2 / New».
− «F3 / Delete».
− «F4 / Rename». Renaming the limit plan in cursor position.
− «F5 / Drive».
flash drive.
− «F6 / Select».
4.3.13.2. Limit Plan Editing
The screen view is shown in figure 4.23:
Figure 4.22
Reading and editing the limit plan in cursor position.
Creating a new limit plan.
Deleting the limit plan in cursor position.
Limit plans source drive selecting: internal drive or USB
Selecting the limit plan in cursor position.
35