Planar IT-100 Operating Manual page 41

The channel can be selected on the map using the ►, ◄,
under the map indicates the channel measurement results in the cursor position. Press the
F2 / Details or ENTER key to view the detailed measurement results for the selected
channel as shown in fig. 4.28.
The table indicates the parameters of measurement results checking against the limit
plan, as well as measured parameters for current channel. The parameter value is
highlighted in red if it does not satisfy the test criterion. The parameter value is not
indicated if this parameter measurement is disabled in the channel plan or CDL page
parameters.
Use the «F2 / ◄Ch » and «F5 / Ch► » keys to scroll through the channels without
leaving to the common table. To scroll through the channels with errors use the «F3 /
◄Error » and «F4 / Error► » keys.
To return to the common page parameters view press «F3 / Back» or «EXIT» key.
4.3.14.4. Delta Mode
This mode presents data in the form of a bar graph as in the Graph mode, but the
length of a bar indicates the difference between the level value in CDL and currently
measured channel level value. The positive value indicates that the CDL level value is
higher than the measured level value, and vice versa. The measured level values are at
the same time checked against the limit plan. The channel plan and the limit plan are
obtained from the CDL. The sample view of the Delta mode is shown in figure 4.29.
Figure 4.27
Figure 4.28
41
and keys. The table