Planar IT-100 Operating Manual page 17

Click on one of the functional keys with the desired icon to select the measurement
mode. Press «EXIT» to return to the selection menu.
On the functional keys panel, «F1» is used to open the setting menu, and «F2» to
«F6» are used to set up the current mode. Press the «Shift» key to display the functional
keys which enable quick switching between measurement modes.
4.3.1.2. Screen view in measurement modes
The screen view in all measurement modes has common elements and settings, as
shown in figure 4.3.
The spaces are aimed to display the following information:
1) Current mode name;
2) Modes and settings icons;
3) RF input or output voltage value;
4) Optical power value in case optical input is selected;
5) Battery charge status and remaining time;
6) Current mode parameters and measuring channel parameters;
7) Automatic limit plan test results;
8) Selected channel name;
9) Selected channel number.
Modes and settings icons are the following:
LNB power 22 kHz modulation mode
Conditional access module (CAM) found
Device connected to PC via USB port
Selected channel synchronization indicator
Selected input indicator: RF (radio frequency) or OP (optical).
4.3.1.3. Navigation
Channel or frequency navigation (depending on the Setting parameter value and the
selected mode) is carried out by the «◄» and «►» keys or alphanumeric keys. To select a
special channel, start its entry with the «.space» key. Press «ENTER» after you complete
Channel Scan
Figure 4.3
Spectrum
17