Table of Contents
Advertisement
To enter an arbitrary command, press the F3 / New key. You have to enter three to
six bites in hexadecimal format (0 to 9 digits, A to F letters) in the popup field.
To repeat a recently sent command, select the needed command by the
keys and press F2 / Repeat.
In case the command sent implies a response, the Received column will indicate a
bite set received from a slave device and the command progress status:
1) Ок. The command is received;
2) not supported. The command is not supported by the device;
3) not recognized. The command is received with an error;
4) parity error. The command is received with an error.
To clear the command history, use the F4 / Clear key.
To enable or disable the LNB power supply source, use the power source control
mode. To select the mode, press Shift and .space /
To go to Channel, MER/BER and Spectrum measurement modes, use the F2, F3
and F4 keys in the additional panel of functional keys accessed by the Shift key.
4.4.7. DiSEqC positioner operating
To operate the DiSEqC positioner in the Channel, MER/BER and Spectrum
measurement modes, the control mode of basic DiSEqC positioner functions is available.
The mode can be enabled in the dropdown menu of F1 / Settings using the Motor
Control option:
1) Off. The control is disabled;
2) Stepwise. The control is enabled, movement is incremental;
3) Continuously. The control is enabled, movement is continuous.
Enabling the DiSEqC control mode results in F3 to F6 functional keys reassignment:
1) F3 / ◄ W – westward movement;
2) F4 / E ► – eastward movement;
3) F5 / Stop – positioner stop;
4) F6 / Motor – positioner commands menu:
− Go home. The command enables positioner moving to the starting position;
− Goto position. The command enables positioner moving to the earlier saved
position. You need to specify the position number (1...99);
− Save position. The command enables the current position saving under the
given number. You need to specify the position number (1...99);
− Set East limit. The command enables setting the current position as
maximum when moving to the east;
− Set West limit. The command enables setting the current position as
maximum when moving to the west;
− Delete limits. The command enables deleting the earlier defined east and
west limits.
4.4.8. Transponder reception quality monitoring
This mode displays timing diagrams of transponder reception quality parameters in
the given time interval.
The mode operation principle is similar to the quality parameters monitoring mode for
terrestrial TV channel reception (section 4.3.10).
simultaneously (section 4.3.1.5).
50
and
Advertisement
Table of Contents
