Operating Modes Setting - Planar IT-100 Operating Manual

The screen view includes common elements and settings in all measurement modes
as shown in figure 4.30.
The fields on the screen indicate the following information:
1) Current measurement mode name
2) Modes and settings icons (section 4.3.1.1)
3) Voltage value at the RF input (section 4.3.1.5)
4) Optical power value, in case optical input is selected
5) Battery charge status and remaining time
6) Current measurement mode parameters and channel parameters
Transponder parameters: frequency, polarization and symbol rate.
7)
The «F1» key on the functional keys panel is used to open the settings menu. The
«F3» to «F6» keys enable the current mode setting. Press the «Shift» key to display the
functional keys for quick switching between the measurement modes.
The LNB settings menu («F2» key) contains a list of parameters which can be
selected using the « » and « » keys, and set up using the «◄» and «►» keys.
In case measuring is performed with LNB profile selected, the following list of LNB
parameters is available:
1) Satellite. The selected LNB satellite name. The information parameter cannot
be edited.
2) LNB. Selection of LNB: LNB1 to LNB4 . 2...4 converters (available if LNB
profile contains more than one converter). For the SCR converter the
parameter enables the slot selection.
3) LO. Selection of converter heterodyne: Low, High.
4) Polarization. Selection of LNB polarization: V – vertical, H – horizontal, L –
left-handed circular, R – right-handed circular.
In case operating is performed without LNB profile the following list of LNB
parameters is available:
1) Tone 22 kHz. Switching on/off 22 kHz tone;
2) Voltage. Target LNB voltage: 13, 18 V.

4.4.2. Operating Modes Setting

The parameters setting program is used for setting the device operation parameters
in the satellite TV broadcasting mode. The
to this mode. The parameters setting screen view is shown in figure 4.31:
Figure 4.30
icon in the satellite TV folder corresponds
43