Data Logger Handling; Lnb Configuration Setting Mode - Planar IT-100 Operating Manual

Multisystem tv analyzer

Table of Contents

4.4.9. Data Logger Handling

The Data logger (DL) is used to save the setting profiles. The Analyzer features two

types of structures referring to DL: LNB configurations table and satellite parameters table.

The data logger memory is common for all types of structures and is allocated

dynamically. The memory capacity allows storing up to 99 LNB profiles (section 4.4.10.2),

and up to 999 satellite parameters pages each of which may contain up to 300

transponders (section 4.4.11). The Analyzer allows viewing, creating and editing the saved

data off-line. The following icons correspond to the DL modes:

The LNB configuration tables are available for making the Analyzer application

convenient in a specific system containing a reception satellite antenna, one or several

LNB converters and signal routing network with DiSEqC switches. The table sets up the

converter parameters, polarization control and LO selection methods, converter access

method, and satellite parameters.

LNB configuration consists of the following parameters:

1) Configuration name;

2) LNB converters number;

3) Parameters of each of LNB converters;

4) Satellite, attached to each of LNB converters;

There is a non-editable LNB configuration «Without converter». When selected, it

gives possibility to manually control LNB voltage and 22 kHz tone, as well as to send

DiSEqC commands.

4.4.10.1. LNB configuration list

This mode allows creating, deleting, editing and selecting LNB configuration, as well

as setting up the parameters of converters and attached satellites. The screen view of this

mode is shown in figure 4.36.

Use the functional keys to perform the following operations with satellites:

− «F1 / Edit».

(section 4.4.10.2).

LNB Configurations

Table

Figure 4.36

Reading and editing the configuration in cursor position

Satellite Parameters

Table

Table of Contents