Table of Contents
Advertisement
Add Relays to the
440R-ENETR Interface
There are two ways to add relays to the Ethernet module.
• Upload relays
This preferred method requires the physical system to be complete,
including relays, taps, and communications with the Ethernet Module.
• Manually enter relays
This method can be used before the physical system being complete.
This method requires you to select each relay in its specific location. If a
DG relay is used, you must also select the type of tap and its specific
location in the GuardLink circuit. For more information, see
Method on page
Upload Method
Verify that you have downloaded the Studio 5000 project into the controller.
1. Go offline.
2. In the Controller Organizer, click the Ethernet Module.
3. On the General tab, click the Change button.
1
4. Click the Upload button.
Rockwell Automation Publication 440R-UM015C-EN-P - April 2018
440R-ENETR Network Interface Add-on Profile
65.
2
Chapter 9
Manual
3
63
Advertisement
Table of Contents
