Table of Contents
Advertisement
Chapter 9
440R-ENETR Network Interface Add-on Profile
66
In
Figure
47, the DG safety relay has been added to Slot 1 (the relay next
to the 440R-ENETR interface). Each DG safety relay can have up to
two GuardLink connections. By default, both GuardLink connections
are disabled.
Figure 47 - Module Definition - DG Safety Relay Added
Now, you can add a tap to the GuardLink connection
4. Right-click a GuardLink connection.
IMPORTANT A GuardLink connection can be added to either [1] or [2] or both.
5. Click Add Device.
6. Click the desired tap. The type of tap must be the same as the physical
location of the selected tap. In this example, select the OSSD 8-pin.
Figure 48 - Add a Tap
4
In
Figure
49, the OSSD 8-pin is Node 1 (7). This tap is electrically
closest to the DG safety relay.
Figure 49 - Tap 1 Is Defined as Node 1
Rockwell Automation Publication 440R-UM015C-EN-P - April 2018
5
7
(Figure
48).
6
Advertisement
Table of Contents
