Table of Contents
Advertisement
Add-on Profile (AOP)
Add a 440R-ENETR Interface
to the Project
440R-ENETR Network Interface Add-on Profile
Status and control signal can be sent from the DG safety relay to the machine
control system over EtherNet/IP by using the 440R-ENETR network
interface.
To use the 440R-ENETR network interface in a Logix Designer project, you
must download and install the AOP. Download firmware and associated files
(such as AOP, DTM, and EDS) from the
Download Center
(PCDC).
The DG safety relay is included with the release of Series B.
With the AOP downloaded and installed,
to add the 440R-ENETR interface to the I/O Configuration.
1. Right-click the Ethernet identifier.
2. Click New Module.
Figure 43 - Controller Organizer
1
Rockwell Automation Publication 440R-UM015C-EN-P - April 2018
Product Compatibility and
Figure 43
2
9
Chapter
shows the beginning steps
61
Advertisement
Table of Contents
