Table of Contents
Advertisement
Change the Order of the
Devices
Repeat the steps
GuardLink chain. Remember that the order of the types of modules
must be the same as the physical taps.
Repeat the process for the second GuardLink chain, if a second
GuardLink chain is used. If not, then the second input (terminals S32
and S42) automatically configures for one safety device during the
configuration process.
IMPORTANT The nodes must be sequential and must not have any gaps in the positions.
The order of the devices can be modified in one of two ways.
• Change the node value to a number greater than the last node. In
Figure
50, node 4 can be changed to node 8 or higher.
Figure 50 - Node Change
• Right-click the device and click Delete Device as shown in
confirmation window appears. Click Yes to confirm delete.
Figure 51 - Node Delete
Once deleted, node 4 is empty. The node must be refilled with a module,
or the higher numbered nodes must be renumbered to remove empty
position.
Rockwell Automation Publication 440R-UM015C-EN-P - April 2018
440R-ENETR Network Interface Add-on Profile
4...6
to add as many modules that exist in the
Chapter 9
Figure
51. A
67
Advertisement
Table of Contents
