YOKOGAWA WT310EH User Manual page 5

How to Use This Manual
Symbols and Conventions Used in Procedural Explanations
In chapters 1 to 4, the contents of the procedural explanations are indicated using the following
symbols.
Procedure
Example: Operations for setting the GP-IB address
Select the
communication function.
1.
The above flow chart indicates the following operations.
You can configure items that are blinking.
1. Press INTERFACE.
A menu appears in display B.
Use ▲ or ▼ to select GPib.
2.
Pressing either key cycles through 4 menu items.
3.
Press SET to confirm the selection of GPib.
The GPib function menu that you selected in step 2 appears in display D.
Use ▲ or ▼ to select the GP-IB address.
4.
If necessary, press the SHIFT key so that it illuminates, and then press ▼ to move the input
5.
digit.
6. Press SET to confirm the setting and return the menu display to the measurement data display.
The selected or set item is confirmed when you press SET.
• When you are making a number positive (no sign) or negative (–) or setting a number, when the
digit in the display that the input will be added to is blank, an underscore flashes at the position
of the digit.
• While you are performing menu operations, to leave the menu display, press HOLD (ESC). All
setting changes that you have confirmed by pressing the SET key will be reflected in the settings.
Explanation
Symbols Used in the Syntax
The following table contains the symbols that are used in the syntax discussed mainly in chapters 5
and 6. These symbols are referred to as BNF (Backus-Naur Form) symbols. For details on how to
write data using these symbols, see pages 5-6 and 5-7.
Symbol Meaning
<>
{}
|
[]
iv
Operations are explained using flowcharts. See the example below for an
explanation of how various operations are indicated. All procedures are written
under the assumption that you are starting operation at the beginning of the
procedure, so you may not need to carry out all the steps in a procedure when
you are changing the settings.
(Display B)
2.
This section describes the setup items and the limitations regarding the
procedures.
Example
A defined value ELEMent<x> <x> = 1 to 3
Select an option in { }
MODE {RMS|VMEan|DC}
Exclusive OR
Can be omitted NUMeric[:NORMal]:VALue?
Set the address.
3
. (Display D)
4.
Press and
5.
Press
6
.
Set, close menu.
to set the number.
to move the digit.
Example of Input
ELEMENT2
MODE RMS
NUMERIC:VALUE?
IM WT310E-17EN