YOKOGAWA WT310EH User Manual page 44

6.1 List of Commands
Command
STORe Group
:STORe?
:STORe[:STATe]
:STORe:INTerval
:STORe:PANel
SYSTem Group
:SYSTem?
:SYSTem:MODel?
:SYSTem:SUFFix?
:SYSTem:SERial?
:SYSTem:VERsion[:FIRMware]?
:SYSTem:KLOCk
:SYSTem:RESolution
:SYSTem:COMMunicate:COMMand
:SYSTem:COMMunicate:ETHernet:
MACaddress?
Common Command Group
*CAL?
*CLS
*ESE
*ESR?
*IDN?
*OPC
*OPC?
*OPT?
*RST
*SRE
*STB?
*TRG
*TST?
*WAI
6-4
Function
Queries all storage settings.
Sets or queries the storage on/off state.
Sets or queries the storage interval.
Saves setup parameters to a file.
Queries all system settings.
Queries the model code.
Queries the suffix code.
Queries the serial number.
Queries the firmware version.
Sets or queries the on/off state of the key protection.
Sets or queries the numeric data display resolution.
Sets or queries the command type.
Sets or queries the Ethernet MAC address.
Executes zero calibration (zero-level compensation, the same operation as
pressing CAL (SHIFT+SET)) and queries the result.
Clears the standard event register, extended event register, and error queue. 6-34
Sets or queries the standard event enable register.
Queries and clears the standard event register.
Queries the instrument model.
Sets bit 0 (the OPC bit) of the standard event register to 1 upon the
completion of the specified overlap command.
Returns ASCII code 1 if the specified overlap command has finished.
Queries the installed options.
Initializes the settings.
Sets or queries the service request enable register value.
Queries the Status Byte Register value.
Executes single measurement (the same operation as when SINGLE
(SHIFT+HOLD) is pressed).
Executes a self-test and queries the result.
Holds the execution of the subsequent command until the completion of the
specified overlap command.
Page
6-32
6-32
6-32
6-32
6-33
6-33
6-33
6-33
6-33
6-33
6-33
6-33
6-33
6-34
6-34
6-34
6-34
6-34
6-35
6-35
6-35
6-35
6-35
6-35
6-36
6-36
IM WT310E-17EN