YOKOGAWA WT310EH User Manual page 36

5.2 Commands
Upper-level Query
An upper-level query is a query that is made by
appending a question mark to a command higher in the
group. The controller can receive all of the settings in
a group collectively by executing a highest-level query.
Some query groups which are comprised of more than
three hierarchical levels can output all the lower level
settings.
Example :INTEGrate?<PMT> -> :INTEGRATE
:MODE NORMAL;TIMER 0,0,0<RMT>
The response to an upper-level query can be sent
back to this instrument as a program message. This
enables the settings that were present when the upper-
level query was made to be reproduced later on.
However, some upper-level queries do not return setup
parameters that are not currently in use. Exercise
caution because not all of a group's information is
necessarily returned in a response.
Header Interpretation Rules
This instrument interprets the header that it receives
according to the rules below.
• Mnemonics are not case sensitive.
Example " INPut " can also be written as " input " or
" INPUT ."
• The lower-case characters can be omitted.
Example " INPut " can also be written as " INPu " or
" INP ."
• The question mark at the end of a header indicates
that it is a query. You cannot omit the question mark.
Example The shortest abbreviation for " INPut? " is
" INP? ."
• If the <x> (value) at the end of a mnemonic is
omitted, it is interpreted as a 1.
Example If " ELEMent " is written as " ELEM ,"
it means " ELEMent1 ."
• Parts of commands and parameters enclosed in
square brackets ([ ]) can be omitted.
Example " [:INPut]:SCALing[:STATe] ON " can
be written as " SCAL ON ."
However, the last section enclosed in square
brackets cannot be omitted in an upper-level query.
Example " SCALing? " and " SCALing:STATe? " are
different queries.
5-4
IM WT310E-17EN