Utility Mode; English Display; Obis Display - Elster A1140 User Manual

26
A1120/40 - Electronic Polyphase Meter
14.3.2

Utility Mode

It is necessary to break the seal on the Reset Pushbutton to enter 'Utility' mode.
The mode is entered by pressing the Reset Pushbutton. 'Utility' appears on the display.
Single presses of the Display pushbutton will then step through the utility displays.
The display will default to autocycle mode at a programmed time after the last press of the
Display Pushbutton, or if the Reset Pushbutton is again pressed.
14.3.3

English Display

Chevrons & Identifiers
The chevrons on the display have the following meaning:
Chevron/Description
The display identifiers give a description of the main register displayed.
Examples of the display are shown in Figures 7.
A full list of displays is given in Figure 8.
14.3.4

OBIS Display

The OBIS code gives a description of the main register displayed.
Chevron 7 indicates the register is active.
Examples of displays and a full list of displays are given in Figures 7
and 8 respectively.
© Elster Metering Limited - M181 001 2G - 5/2010
1 Import
2 Export
3 -
4 Security
5 -
6 -
7 -
Short press Reset Pushbutton
Press Display Pushbutton
Next display
Identifiers
Description
Import
OBIS Code
1 2 3 4 5 6 7
Security
Export
Active