How To Configure Sdi With Ramp Monitoring - ABB FSO-21 User Manual

312 Configuration
SDI positive
Inputs
Speed
SDI.21
= DI X113:2 &
X114:2
SDI.22
= None


How to configure SDI with ramp monitoring

Example: The figure below shows an example of an SDI positive function with ramp
monitoring set-up:
• Version 1 of SDI functions activated
• SDI positive function activated
• monitored deceleration ramp
• deceleration ramp and monitoring limits according SAR1 parameters (see section
Configuring SAR
• SDI tolerance into the forbidden direction 2 degrees
(SDI.14 SDI tolerance limit degree
• automatic acknowledgement
• redundant activation button connected to input
(SDI.21 SDI positive input A
• single output connected
SDI.01
SDI.13
SDI.10
SDI.12 = 2000 ms
SDI monitoring started
SDI activated
(SDI.02 SDI positive activity
(SDI.10 SDI activation monitoring method
on page 294)
= 2 deg)
(SDI.13 SDI acknowledgement
= DI X113:2 & X114:2)
(SDI.23 SDI positive output A
= Version 1
= Automatic
= Time
(SDI.01 SDI version
= DO X114:7).
Outputs
SDI.23
= DO X114:7
SDI.24
= None
SDI.14 = 2 deg
Time
(not shown in the
figure)
= Version 1)
= Enabled)
= Ramp)
= Automatic)