Fena Module Replacement; Replacing The Fena Module - ABB FSO-21 User Manual

FENA module replacement

If you have to replace the FENA Ethernet adapter module, for example, because of a
serious hardware failure, follow the procedure below.


Replacing the FENA module

1. Stop the driven machinery and prevent an unexpected start-up.
2. Disconnect the supply with the supply disconnecting device.
3. Replace the FENA module according to the instructions in FENA-01/-11/-21
Ethernet adapter module user's manual (3AUA0000093568 [English]).
4. Assign the device name for the FENA module from the safety PLC (see section
Configuring the ABB AC500-S Safety PLC
Siemens SIMATIC Fail-safe S7 PLC
5. Perform the start-up procedure according to chapter Start-up.
6. Perform the validation procedure for the PROFIsafe communication according to
section Validation of the PROFIsafe connection
7. Update the HW and SW versions of the new FENA module to the logbook of the
driven machine.
on page 196
on page 208.
on page 377.
Maintenance 421
or section Configuring the