Configuring The Fso Module - ABB FSO-21 User Manual

248 Configuration

Configuring the FSO module

The FSO parameters are set with the Drive composer pro PC tool. The names of the
FSO parameters and parameter settings are shown in the manual as they appear on
the screen when using the tool. See Drive composer PC tool user's manual
(3AUA0000094606 [English]) for instructions on using the tool.
You must always check all parameter values to make sure that they are suitable for
your application. The pre-set values in a delivered FSO module or factory default
values are not valid for any safety application as such.
Note: Configuration is only possible when the drive is not modulating or the FSO is in
the Safe state.
Note: After you initially start up the FSO and also after you later modify any
application parameters or the configuration, you must check the safety of the entire
system by doing a verification according to the system safety verification plan and by
doing a validation of the correct operation of the safety application. See chapter
Verification and validation.
To configure the FSO, do the steps shown in the diagram below:
Configuration
1
Plan configuration
2
3
Print, sign and file the configuration report
Do commissioning tests
Print, sign and file the commissioning report
Configure