Factory Reset - ABB FSO-21 User Manual

Factory reset

Do a factory reset if
• you forget the password
• you want to do the configuration again from scratch.
Note: The factory reset clears the configuration and takes the factory default
values back in use. These factory default values are not the same as the pre-set
values in a delivered FSO (ordered with a plus code). The factory default values
are invalid for restart. The FSO needs a full reconfiguration before it can be
restarted. You can also use the safety file that was saved at the first start-up
(see page 249).
1. Make sure that the motor is stopped.
2. Lift the Factory reset label to the right of the I/O terminals and push the button
underneath with for example a pen until the LEDs start to blink (about 5 seconds).
This returns the factory settings (parameters, including the password) to the FSO.
1. Reconfigure the safety functions with the Drive composer pro PC tool. To be able
to restart the drive, make sure that at least these parameters are set to suitable
values according to your application:
Parameter
index
FSOGEN.21
FSOGEN.22
FSOGEN.41
STO.02
STO.13
STO.14
SBC.11
SLSx.02
2. Specify a new password with the tool.
Name
Motor nominal speed
Motor nominal frequency
Power-up acknowledgement
STO acknowledgement
Restart delay after STO
Time to zero speed with STO and
modoff
STO SBC usage
SLS acknowledgement
1
Factory default
value
100.0 rpm
1 Hz
Manual
Manual
3,600,000 ms
3,600,000 ms
Delayed brake
Manual
Maintenance 423
Pre-set value
(with option
+Q972)
1500.0 rpm
50 Hz
Automatic
Automatic
2000 ms
2000 ms
None
Automatic