Configuration 255
Configuring I/O
How to configure I/O
To configure the I/O, set the FSO parameters shown in the figure below to
appropriate values using the Drive composer pro PC tool. See parameter group
SAFEIO
on page 201.
The location of the input and output terminals on the FSO module is shown in section
Layout
on page 27.
Inputs
Set the length and period of the diagnostic pulse for the digital inputs. Select for each
input whether the diagnostic pulse is on or off.
Outputs
Set the logic state for each digital output. Set the length and period of the diagnostic
pulse for the digital outputs. Select for each output whether the diagnostic pulse is on
or off.