Table of Contents
Advertisement
Configuring LD 810HSE Ex
Although the Linking Device is delivered with a pre-configured IP address
(192.168.0.10), it must be assigned an IP address from your LAN address
range. Furthermore, subnet mask and gateway IP address must be set accord-
ingly. This information is referred to as IP configuration.
The IP configuration can be changed via Ethernet by means of a web browser
(HTTPS protocol, recommended). See the User Manual (2PAA114135-610) for
the password of the web server interface. In addition, if a DHCP server is avail-
able, the LD 810HSE Ex can be configured to use a DHCP address.
22 Quick Installation Guide LD 810HSE Ex | 2PAA118721
Make sure that the LD 810HSE Ex and the PC are in the same
network.
For commissioning of LD 810HSE Ex, refer to the LD 810HSE Ex
User Manual (2PAA114135-610) available in the MyABB portal
(https://myportal.abb.com/home).
Before commissioning of LD 810HSE Ex, make sure to use the
latest and recommended Linking Device firmware released for your
system environment.
Advertisement
Table of Contents
