Part Names and Functions
The following describes the names and functions of parts of the Sensor Head, Calibration
ROM and Controller.
Sensor Head
No.
Names
1
Projector/receiver
2
Serial number
3
Fiber interface
4
Fiber Cable
5
Fiber Connector
Calibration ROM
This ROM is associated with the sensor on a one-to-one basis, and operates connected to
the Controller.
No.
Names
1
Serial number
Use with the Calibration ROM always connected. If the Calibration ROM is not connected, an error is
displayed.
Projects and receives light.
Serial number.
Only a calibration ROM with the same serial number is available.
Interfaces the Sensor Head and optical fiber (unremovable).
Sends or receives light signals to/from the Controller.
Couples the Controller and fiber cable.
Serial number.
Only a Sensor Head with the same serial number is available.
Part Names and Functions
Functions
Functions
Chapter 1
ZW
1-3
User's Manual