Operational Commands - Omron MicroHAWK Integration Manual

Operational Commands

Operational Commands

Note: For a list of all K commands, see Serial Configuration Commands.
Type
Counter Request/Clear
Firmware Verification
Read Rate
Device Control
Read Cycle
Enable/Disable
Parameter Reset/Save
Resets
14-2
Command
<q>
<q0>
<$>
<$0>
<N>
<O>
<T>
<U>
<V>
<W>
<X>
<Y>
<#>
<#a>
<#b>
<!>
<!a>
<!b>
<!s>
<C>
<Cp>
<J>
<a1>
<L1>
<L2>
<L3>
<I>
<H>
1
<l1>
2
<l0>
<A?/1>
<A?/0>
<A>
<Ard>
<Arp>
<Arc>
1
<l1> = lowercase 'L', one
2
<l0> = lowercase 'L', zero
Name
No-Reads Per Read Cycle Counter
No-Reads Per Read Cycle Counter Reset
Mismatch Per Read Cycle Counter
Mismatch Per Read Cycle Counter Reset
No-Read Counter
No-Read Counter Reset
Trigger Counter
Trigger Counter Reset
Match Code Counter
Match Code Counter Reset
Mismatch Counter
Mismatch Counter Reset
Request All Part Numbers
Request Application Firmware Part Number
Request Boot Code Firmware Part Number
Request All Firmware Checksums
Request Application Firmware Checksum
Request Boot Code Firmware Checksum
Request Current Parameter Settings Checksum
Decodes Per Second Test
Decode Percent Test
Exit Read Rate Tests
Preface PDF417 Output with Data Attributes
Pulse Programmable Output 1
Pulse Programmable Output 2
Pulse Programmable Output 3
End Current Read Cycle until <H>
Enable Read Cycle after <I>
Activate Targeting System
Deactivate Targeting System
Complete Reset when Resets or Save for Power-On
Command Has Been Issued
Warm Reset if Power-On Command Has Been Issued
Software Reset, Current Parameters Retained
Software Reset, Recall Default Parameters except
Communication and Custom Unit Name Parameters
Software Reset, Recall Power-On Default Parameters
Software Reset, Recall Customer Default Parameters
MicroHAWK Engine Integration Guide