Dotcode - Omron MicroHAWK Integration Manual

DotCode

Important: When DotCode is enabled, no other symbologies will be decodable. You must
disable DotCode to decode symbols of any other type.
DotCode Status
Serial Cmd: <K497,status,rotation mode>
Default: 0 = Disabled
Options: 0 = Disabled
1 = Enabled
Disabled
The reader will not attempt to decode DotCode symbols.
Enabled
The reader will attempt to decode DotCode symbols.
Rotation Mode
Serial Cmd: <K497,status,rotation mode>
0 = No Rotation
Default:
Options: 0 = No Rotation
1 = Low Rotation
2 = Omnidirectional
No Rotation
The reader will decode horizontal and vertical symbols (+/– approximately 3 degrees).
Low Rotation
The reader will decode +/– approximately 10 degrees from the horizontal or vertical
symbols. It is slightly slower than the No Rotation option.
OmniDirectional
The reader will support 360 degree reading. Omnidirectional is significantly slower than
the other two options.
MicroHAWK Engine Integration Guide
Symbologies
7-39