Default/Reset/Save - Omron MicroHAWK Integration Manual

Default/Reset/Save

Understanding and controlling your reader's active, saved, and default settings is critical to
its successful operation.
Reset
Reset and Recall Defaults
Reset and Recall Power-On Parameters
Reset and Recall Customer Default
Parameters
Save Current Settings for Power-On
Save Current Settings as Customer
Default Parameters for Power-On
Recall Default Parameters and Save for
Power-On
Recall Customer Default Parameters and
Save for Power-On
a. When you right-click in a menu tree and select Default Current Menu Settings or Default All ESP
Settings, it is important to note that only ESP settings are defaulted. To save these defaults to the
reader itself, you need to follow up with a Save to Reader, Send and Save command.
b. Only available in ESP if enabled under the Options dropdown menu.
Resets
Resets ("A" commands) affect only the current settings (active memory) and are not saved
for power-on.
Saved for Power-on
Power-on parameters ("Z" commands) are saved to NOVRAM and recalled and loaded
into current parameters when power is cycled to the reader or the <Arp> command is
issued.
Defaults
Defaults are Omron Microscan firmware settings or saved customer settings that can be
recalled, either by software or hardware reset.
MicroHAWK Engine Integration Guide
Function
Serial ESP (first, right-click in any
menu tree)
Cmd
Save to Reader,
<A>
Send No Save
<Ard>
<Arp>
<Arc>
Save to Reader,
<Z>
Send and Save
Save to Reader,
<Zc> Send and Save Customer
Defaults for Power-On
<Zrd>
<Zrc>
Utilities
a
No
No
No
b
No
No
14-19