Read Cycle Setup - Omron MicroHAWK Integration Manual

Read Cycle Setup

Read Cycle Setup

Setting up read cycle and triggering parameters will involve a series of decisions based on
your particular application, as follows:
1. Select the number of symbols to be read in a single cycle. The MicroHAWK Engine
can read multiple symbols in a single image frame.
2. Decide on the trigger type to be used: if serial, choose a serial character; if external,
choose either Level or Edge.
3. Designate how the read cycle should end (Timeout, New Trigger, Last Frame).
4. Select Capture Mode, Continuous Mode, or Rapid Mode.
5. Select Number of Captures (if in Rapid Capture Mode).
6. Set the Time Before First Capture and Time Between Captures, if any.
Note: The capture rate increases as the frame size decreases.
6-4
MicroHAWK Engine Integration Guide